Service-Policy Input - Cisco Nexus 7000 Series Command Reference Manual

service-policy input

service-policy input
To attach a control plane policy map to the control plane, use the service-policy input command. To remove
a control plane policy map, use the no form of this command.
service-policy input policy-map-name
no service-policy input policy-map-name
Syntax Description
policy-map-name
Command Default
None
Command Modes
Control plane configuration
Command History
Release
4.0(1)
Usage Guidelines
You can use this command only in the default virtual device context (VDC).
You can assign only one control place policy map to the control plane. To assign a new control plane policy
map to the control plane, you must remove the old control plane policy map.
This command does not require a license.
Examples This example shows how to assign a control plane policy map to the control plane:
switch# configure terminal
switch(config)# control-plane
switch(config-cp)# service-policy input PolicyMapA
This example shows how to remove a control plane policy map from the control plane:
switch# configure terminal
switch(config)# control-plane
switch(config-cp)# no service-policy input PolicyMapA
Related Commands
Command
policy-map type control-plane
Cisco Nexus 7000 Series Security Command Reference
652
Name of the control plane policy map.
Modification
This command was introduced.
Description
Specifies a control plane policy map and enters policy
map configuration mode.
S Commands