Show Ipv6 Dhcp Guard Policy - Cisco Nexus 7000 Series Command Reference Manual

show ipv6 dhcp guard policy

show ipv6 dhcp guard policy
To display Dynamic Host Configuration Protocol for IPv6 (DHCPv6) guard information, use the show ipv6
dhcp guard policy command.
show ipv6 dhcp guard policy [policy-name]
Syntax Description
policy-name
Command Modes
Any command mode
Command History
Release
8.0(1)
Usage Guidelines
If the policy-name argument is specified, only the specified policy information is displayed. If the policy-name
argument is not specified, information is displayed for all policies.
Examples The following is sample output:
switch# show ipv6 dhcp guard policy
Dhcp guard policy: default
Dhcp guard policy: test1
Dhcp guard policy: test2
The table below describes the significant fields shown in the display.
Table 1: show ipv6 dhcp guard policy
Field
Device Role
Cisco Nexus 7000 Series Security Command Reference
816
Device Role: dhcp client
Target: Et0/3
Device Role: dhcp server
Target: vlan 0 vlan 1
Max Preference: 200
Min Preference: 0
Source Address Match Access List: acl1
Prefix List Match Prefix List: pfxlist1
Device Role: dhcp relay
Target: Et0/0 Et0/1 Et0/2
(Optional) DHCPv6 guard policy name.
Modification
This command was introduced.
vlan 2 vlan 3 vlan 4
Description
The role of the device. The role is either client, server
or relay.
Show Commands