Cts Sxp Reconcile-Period - Cisco Nexus 7000 Series Command Reference Manual

C Commands

cts sxp reconcile-period

To configure a Security Group Tag (SGT) Exchange Protocol (SXP) reconcile period timer, use the cts sxp
reconcile-period command. To revert to the default, use the no form of this command.
cts sxp reconcile-period seconds
no cts sxp reconcile-period
Syntax Description
seconds
Command Default
60 seconds (1 minute)
Command Modes
Global configuration
Command History
Release
4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
After a peer terminates an SXP connection, an internal hold down timer starts. If the peer reconnects before
the internal hold down timer expires, the SXP reconcile period timer starts. While the SXP reconcile period
timer is active, the Cisco NX-OS software retains the SGT mapping entries learned from the previous connection
and removes invalid entries.
Setting the SXP reconcile period to 0 seconds disables the timer and causes all entries from the previous
Note
connection to be removed.
This command requires the Advanced Services license.
Examples This example shows how to configure the SXP reconcile period:
switch# configure terminal
switch(config)# cts sxp reconcile-period 120
This example shows how to revert to the default SXP reconcile period value:
switch# configure terminal
switch(config)# no cts sxp reconcile-period
Number of seconds. The range is from 0 to 64000.
Modification
This command was introduced.
Cisco Nexus 7000 Series Security Command Reference
cts sxp reconcile-period
185