Dot1X Default - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

dot1x default

Use the dot1x default interface configuration command to reset the IEEE 802.1x parameters to their
default values.
Syntax Description
This command has no arguments or keywords.
Defaults These are the default values:
•
•
•
•
•
•
•
•
•
Command Modes
Interface configuration
Command History Release
12.2(25)SEE
Examples
This example shows how to reset the IEEE 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command
show dot1x
78-17262-01
dot1x default
The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Modification
This command was introduced.
[interface interface-id]
Description
Displays IEEE 802.1x status for the specified port.
Cisco Catalyst Blade Switch 3030 Command Reference
dot1x default
2-67