Dot1X Default - Cisco Catalyst 3750 Command Reference Manual

dot1x default

dot1x default
Use the dot1x default interface configuration command on the switch stack or on a standalone switch
to reset the configurable 802.1x parameters to their default values.
Syntax Description This command has no arguments or keywords.
Defaults
These are the default values:
•
•
•
•
•
•
•
•
•
Command Modes Interface configuration
Command History Release
12.1(11)AX
12.1(14)EA1
Examples This example shows how to reset the configurable 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command
show dot1x
Catalyst 3750 Switch Command Reference
2-68
dot1x default
The per-port 802.1x protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Modification
This command was introduced.
This command was changed to the interface configuration mode.
[interface interface-id]
Chapter 2
Description
Displays 802.1x status for the specified port.
Catalyst 3750 Switch Cisco IOS Commands
78-16181-01