Station Number Setting Of A Local Station; Chapter 7 Parameter Setting - Mitsubishi Electric QJ71GF11-T2 User Manual

CHAPTER 7
This chapter describes CC-Link IE Field Network parameters.
The CC-Link IE Field Network parameters are set for either the master station or slave stations.
This manual describes network parameters for master/local modules. For slave station settings, refer to the manuals
for the slave stations used.
(1) Parameter setting methods
The parameters of the master/local module can be set using GX Works2 or dedicated instruction. Select the
method according to application.
Item
Parameter setting using GX Works2
Parameter setting using a dedicated
instruction (CCPASET instruction)
(a) Station number setting of a local station
The station number of a local station can be also set using the UINI instruction. This allows project data items
other than the station number to be the same. (
• When using GX Works2 for the parameter setting, select "Specify Station No. by Program" in the station
number setting method. Then set the station number using the UINI instruction.
• When using the CCPASET instruction for the parameter setting, set Switch 2 in the intelligent function
module switch setting to 31FF
the station number using the UINI instruction.
PARAMETER SETTING
Application
• To easily configure the setting on the window without
creating a program for the setting
• To automatically transfer data in RX/RY/RWr/RWw/SB/SW
of the master/local module to the device of a CPU module
• To change the parameter settings without resetting the
CPU module
• To mount more master/local modules than the number of
modules that can be set using GX Works2
Page 380, Section 10.18)
. After setting the network parameters using the CCPASET instruction, set
H

CHAPTER 7 PARAMETER SETTING

Reference
Page 84, Section 7.2
Page 359, Section
10.17
7
81