Mitsubishi Electric QJ71GF11-T2 User Manual page 155

Item
Set the own network station where communications are transmitted through to reach the Ethernet device.
Set the routing parameters for all the CPU modules on the communication route.
Set the routing parameters as follows.
Target Network No.
Ex.
station
To transmit communications to the network No.
the IP packet passes through the station
with the own network No.
Relay Network No.
Relay Station No.
*1 When the network address of the Ethernet device and CPU module is the same as that of the master station, the third
octet of the IP address of the Ethernet device side is used as a network number.
When the network address of the Ethernet device and CPU module is different from that of the master station, refer to
the example of communications to access a different network address. (
When the network address of the Ethernet device and CPU module is the same as that of the master
,
and station No. .
Set parameters.
Ethernet device
(request source device)
Network No.
3.
Set the routing parameters.
Project window
Parameter]
button
For details on the routing parameters, refer to the
following.
Description
To transmit communications to the network No.
the IP packet passes through the station
with the own network No.
Set parameters.
Station No. Station No.
Network No.
Network No.
*1
CHAPTER 8 FUNCTIONS
[Parameter] [Network
[Ethernet/CC IE/MELSECNET]
,
and station No. .
Ethernet device
(request destination device)
*1
Page 166, Section 8.3.7 (2))
8
153