How To Configure The Settings On The Window In The Table Format - Mitsubishi Electric QJ71GF11-T2 User Manual

(2) How to configure the settings on the window in the table format

1.
Set network setting parameters. (
2.
Open the setting window.
Project window
3.
Set parameters in the window.
4.
Click the
Item
Select a link device assignment method.
Assignment Method • Points/Start: Enter the points and start numbers of link devices.
• Start/End: Enter the start and end numbers of link devices.
The number of stations set in "Total Stations" of the network settings is
Module No.
displayed.
Select the station type (excluding the master station). Select the
Station No.
station type same as that of the modules connected to the network.
Select the type of stations (excluding the master station). Select the
Station Type
station type of modules actually connected to the network.
Page 84, Section 7.2)
[Parameter] [Network Parameter]
button
button.
Description
CHAPTER 7 PARAMETER SETTING
[Ethernet/CC IE/MELSECNET]
Setting range
• Points/Start
• Start/End
(Default: Start/End)

1 to 120
(Default: Stations are numbered in
consecutive order by the number of
stations set in "Total Stations" in the
network setting.)
• Remote I/O Station
• Remote Device Station
• Intelligent Device Station
• Local Station
• Sub-Master Station
(Default: Intelligent Device Station)
7
97