Module Switch Settings; Setting The Station Number (Station No.) - Mitsubishi Electric Q Series Reference Manual

4 SETUP AND PROCEDURES BEFORE STARTING THE OPERATION

4.3 Module Switch Settings

4.3.1 Setting the station number (STATION NO.)

STATION NO.
10
1
4 - 4
This section explains the preparations that should be made prior to powering on the
network module.
Set the station number of the network module in the network using the station
number setting switches.
The upper switch is for setting a number of tens and the lower switch for setting a
number of single units.
Setting
0
1 to 64
65 to 99
POINT
1) Duplicate station numbers cannot be used in the same network.
2) Any station can be set as the control station as long as the station number is in
the valid setting range.
3) The station number setting does not need to be consecutive. However, when
no number is set to a station, it must be set as a reserved station.
4) When setting, use a station number within the range set at the network
parameter's "Total stations."
Description
With PLC to PLC networks: Setting error.
With remote I/O networks: Valid setup range
Valid setting range
Setting error
MELSEC-Q
4 - 4