Program Example (Parameter Setting In The Local Station); Intelligent Function Module Switch Setting - Mitsubishi Electric QJ71GF11-T2 User Manual

(5) Program example (parameter setting in the local station)

A program example is described below. The program sets parameters to the local station of network number 1
when M181 turns on.
(a) System configuration
The following figure shows a system configuration to set CC-Link IE Field Network parameters for the local
station.
Master station (station No.0)
(b) Intelligent function module switch setting
Before executing the CCPASET instruction, set the intelligent function module switches as follows.
Project window
(c) Devices used in the program
Device
M181
M182
M183
D2700 and D2701
(d) CCPASET instruction setting
• Control data
Device
(S1)+0 D2700 Completion status
(S1)+1 D2701 Setting flag
Network No.1
CPU module
Device
Local station (station No.1)
[Parameter] [PLC Parameter]
Description
Start contact
Completion device
Completion status indication device
Control data
Item
(The system sets this item.)
0100
H
• Data link faulty station setting: Hold
• Output setting during CPU STOP: Hold
CHAPTER 10 DEDICATED INSTRUCTIONS
CCPASET instruction
Master/local module
execution source
(own station)
Parameter settings
"I/O Assignment" tab
Device
D2710
D2720 Dummy device
D2730
-
Setting value
button.
Description
375
10