Program Example (Parameter Setting In The Master Station And Submaster Station) - Mitsubishi Electric QJ71GF11-T2 User Manual

(6) Program example (parameter setting in the master station and submaster
station)
A program example is described below. The program sets parameters to the master station and submaster
station of network number 1 when M191 turns on and the submaster function is used.
(a) System configuration
The following figure shows a system configuration to set CC-Link IE Field Network parameters for the master
station and submaster station.
CPU module
CCPASET instruction
execution source
Device
CPU module
CCPASET instruction
execution source
Device
(b) Intelligent function module switch setting
Before executing the CCPASET instruction, set the intelligent function module switches as follows.
Project window
• For the master station
• For the submaster station
Master station (station No.0)
Master/local module
Parameter settings
Master/local module
Parameter settings
Submaster station (station No.2)
[Parameter] [PLC Parameter]
CHAPTER 10 DEDICATED INSTRUCTIONS
Local station (station No.1)
Network No.1
"I/O Assignment" tab
10
button
377