Table of Contents
Advertisement
4. SETUP AND PREPARATION BEFORE OPERATION
4.4
Station Number Setting
4.5
Facing Direction of the Module Installation
Downloaded from
ManualsNet.com
Point
(1) Set the offset and gain values in the actual usage state.
(2) The offset and gain values are stored in the AJ65BT-64DAV/DAI, and are not erased even
the power supply is shut off.
(3) Perform the offset/gain setting when the programmable controller CPU is stopped. When in
the test mode, D/A conversion is stopped for all channels, so use the remote READY signals
as an interlock.
(4) Perform the offset/gain setting in the range from DC -10 to +10V or from 4 to +20mA. When
the setting exceeds this range, the maximum resolution or total precision may not be in the
range indicated in the performance specification.
By the AJ65BT-64DAV/DAI station number setting, the addresses to store the control I/O signal data
and read/write data are determined.
For details, refer to the user's manual of the master module used.
Panel
When the module is installed next to the panel
search engine
When the module is installed on the panel
4-5
MELSEC-A
Advertisement
Table of Contents
