Mitsubishi Electric QJ71GF11-T2 User Manual page 267

(a) Control data
Device Item
Execution/
(S1)+0
abnormal end type
Setting data
b15 to
0
1) Execution type (bit 0)
0: Without arrival confirmation
•
When the target station is on the same network
The process is completed when data is sent from the own
station.
Request
source
Completed
•
When the target station is on another network
The process is completed when data arrives at the relay station
on the same network.
Request Relay
source station
Completed
1: With arrival confirmation
The process is completed when data is written in the target
station.
Request Relay
source station
Completed
Target
station
When "0: Without arrival confirmation" is specified, the result is
regarded as normal on the own station even if the writing to the target
station fails, as follows.
• When communication ends normally even though sent data are
abnormal
• When data cannot be written to the target station, because
instructions are executed to the same station from multiple stations
(The target station generates an error code (D202
2) Abnormal end type (bit 7)
Specify the data set status in case of abnormal end.
0: After (S1)+11, no data is set for abnormal end.
1: Data at the time of abnormal end is set in the area starting from
(S1)+11.
CHAPTER 10 DEDICATED INSTRUCTIONS
b7 to b0
2 0 1
Target
station
Target
station
Completed
Target
station
or D282 ))
H H
Setting range Set by
0000
H
0001
H
User
0080
H
0081
H
265
10