Setting The Configuration Of The Slave Station In The Master Station - Mitsubishi Electric QJ71GF11-T2 User Manual

(a) Setting the configuration of the slave station in the master station
Item
Mode Setting
Set the mode of the master station. (
Select a link device assignment method.
Assignment Method • Point/Start: Enter the points and start numbers of link devices.
• Start/End: Enter the start and end numbers of link devices.
Link Scan Time
Displays the approximate link scan time.
(Approx.)
The total number of slave stations and submaster stations set in the CC IE
No.
Field configuration window is displayed.
The module model name is displayed.
If a module where the profile is not registered is set, the message "Module
without profile" is displayed. Register the profile before setting the model
Model Name
name.
For how to register a profile, refer to the following.
Enter the station number of each slave station or the submaster station
connected to the network.
STA#
Station numbers do not need to be set consecutively, but must be unique.
The station number of the master station is fixed at "0".
Select the station type (excluding the master station). Select the station type
Station Type
same as that of the modules connected to the network.
Assign RX/RY points. (
Points can be assigned in increments of 16 (Start: 0
When "Sub-Master Station" is selected in "Station Type", points can also be
assigned for the master station. (
RX/RY Setting
To equally assign points or the same points, go to [Equal Assignment] or
[Identical Point Assignment] under [CC IE Field Configuration].
(
90
Description
GX Works2 Version1 Operating Manual (Common)
Page 124, Section 8.1.1)
Page 95, Section 7.3 (1) (d))
Page 84, Section 7.2 (1))
, End: F
H
Page 180, Section 8.8)
Setting range
• Online (Normal Mode)
• Online (High Speed Mode)
• Offline
• H/W Test
• Self-Loopback Test
• Loop Test
(Default: Online (Normal Mode))
• Point/Start
• Start/End
(Default: Start/End)



1 to 120
(Default: Blank)
• Remote I/O Station
• Remote Device Station
• Intelligent Device Station
• Local Station
• Sub-Master Station
(Default: varies depending on the set
module)
• Points:
Station Type
).
H
Master Station, Local
Station, Intelligent
Device Station, Sub-
Master Station
Remote Device Station
Remote I/O Station
• Device number: 0 to 3FFF
(Default: varies depending on the set
module)
Setting
range
16 to 2048
16 to 128
16 to 64
H