6.4.2
Cable test
Cable test checks if the Ethernet cables are properly connected.
Only the Ethernet cable connected to the PORT1 or PORT2 of the target station is tested. For the whole network
status, perform the loop test. (
Station No.0
Station No.1
78
Page 71, Section 6.4.1)
Station No.2
Station No.3
1.
Connect GX Works2 to the CPU module.
2.
Open the "Cable Test" window.
[Diagnostics]
3.
Enter a station number and click the
button to operate the test. If an error occurs, take
corrective actions according to the error message.
[CC IE Field Diagnostics]
button