Using Both The Ccpaset Instruction And Gx Works2; When The Network Configuration Setting Data Exceeds The Total Number Of Slave Stations; Applicable Station Numbers For Reserved Stations And Error Invalid Stations; Parameter Error - Mitsubishi Electric QJ71GF11-T2 User Manual

(3) Precautions
(a) Using both the CCPASET instruction and GX Works2
Network parameters cannot be set using both the CCPASET instruction and GX Works2. If both are used, the
CCPASET instruction will fail.
(b) When the network configuration setting data exceeds the total number of slave
stations
If the number of set network configuration setting data exceeds the total number of slave stations, the data will
be ignored. Only the data set within the total number of slave stations are valid.
(c) Applicable station numbers for reserved stations and error invalid stations
If the station number of a reserved station or error invalid station is outside the range set by total number of
slave stations and network configuration setting data, it is ignored. Only station numbers within the specified
ranges are valid.
(d) Parameter error
If a parameter error occurs, check the error code stored in link special register (SW) and take corrective
actions.
1.
If a parameter is incorrect, execution of the CCPASET instruction will fail.
2.
Check the error code stored in Parameter setting status (SW004C) and take corrective action.
( Page 439, Section 12.5)
CHAPTER 10 DEDICATED INSTRUCTIONS
10
363