Mitsubishi Electric QJ71GF11-T2 User Manual page 537

• Setting parameters for local stations
Item
Enter the network number.
0 0
Switch 1
Enter the station number.
3
Switch 2
Switch 3
Enter "0000
Switch 4
Switch 5
(4) Programming
To write parameters of the master/local module to the buffer memory, use a user program for the C Controller
module.
Sample programs with parameter settings for communications are stored to the folder where "C Controller setting utility" or
"Setting/monitoring tools for the C Controller module" was installed. For the folder structure, refer to the following.
• C Controller setting utility
• Setting/monitoring tools for the C Controller module
(a) Precautions
• Before running a user program for parameter settings, configure the I/O assignment setting and intelligent
function module switch setting with "C Controller setting utility" or "Setting/monitoring tools for the C
Controller module".
• Auto refresh is not performed between the C Controller module and the master/local module.
Exchange data through the buffer memory in the master/local module.
• When the master/local module is mounted with a C Controller module, it cannot communicate with other
stations using transient transmission. For communications with other stations, perform cyclic transmission
using the buffer memory in the master/local module.
• A C Controller module cannot directly access the buffer memory in the intelligent function module mounted
with a remote head module or a head module. When auto refresh is set to the remote head module or the
head module, the buffer memory to be automatically refreshed can be read or written by cyclic
transmission.
Description
H
Network No.: 01 to EF
H
1
H
Station No.: 01 to 78
H
".
H
C Controller Module User's Manual (Utility Operation, Programming)
Setting/Monitoring Tools for the C Controller Module Operating Manual
0001
(1 to 239)
H
3101
(Station number: 1 to 120)
(1 to 120)
H
0000
APPENDICES
Setting range
to 00EF
H H
to 3178
H H
(Fixed)
H
535
A