Jp/Gp.riwt (Writing Data In Target Stations) - Mitsubishi Electric QJ71GF11-T2 User Manual

10.16

JP/GP.RIWT (Writing Data in Target Stations)

This instruction writes data for the specified number of points to the device of the target station.
JP.RIWT
GP.RIWT
Internal device
Setting
(System, user)
*1
data
Bit Word

(S1)

(S2)
(D)
*1 Local devices and file registers set for each program cannot be used.
(1) Setting data
Setting data
Jn
Un
(S1)
(S2)
(D)
Start contact
Start contact
Link direct device
File
J\
register
R, ZR
Bit Word
Description
Own station network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station Access
Start I/O number of the master/local module of own station
(00 to FE : Upper two digits of the I/O number expressed in three
H
digits)
Start device of the own station where control data is stored
Start device of the own station where data to be written is stored
The device of the own station that turns on for one scan upon
completion of the instruction.
If the instruction fails, (D)+1 also turns on.
CHAPTER 10 DEDICATED INSTRUCTIONS
JP.RIWT Jn
GP.RIWT Un
Available devices
Intelligent
function module Index register
device
U\G



(S1) (S2) (D)
(S1) (S2) (D)
Constant
Others
Zn
K, H $
Set by Data type
16-bit binary
User
Device name
System Bit
10
351