Jp/Gp.swrite (Writing Data To The Programmable Controller On Another Station) - Mitsubishi Electric QJ71GF11-T2 User Manual

10.7
JP/GP.SWRITE (Writing Data to the Programmable
Controller on Another Station)
This instruction writes data to the device of the programmable controller on another station. (In units of words)
With the SWRITE instruction, the device of the other station is turned on when data writing is completed. Data writing
with the SREAD instruction can be confirmed by this.
JP.SWRITE
GP.SWRITE
Setting
Internal device
1
(System, user)
data*
Bit Word

(S1)

(S2)
*5
(D1)
(D2)
(D3)
*1 Local devices and file registers set for each program cannot be used.
*2 T, C, D, W, ST, SD, and SW can be used.
When specifying SD/SW, it can be written in the range that the user can set.
For details on SD/SW, refer to the following.
Manuals for the CPU module and network module of the target station
*3 For the SWRITE instruction, the write notification device (D3) can be omitted in the programming.
However, the operation is the same as the WRITE instruction.
The SWRITE instruction can operate differently depending on whether the write notification device (D3) is omitted or not.
*4 When the target station is a Basic model QCPU, the data set in the write notification device (D3) is ignored. (Operation is
the same as the WRITE instruction.)
*5 When the target station is a Basic model QCPU, a Universal model QCPU, an RCPU or an LCPU, a digit-specified bit
device can be used. (
To use digit specification, all the following conditions must be met:
• The device number should be multiples of 16 (10
• The number of digits should be 4 (K4).
276
Start contact
Start contact
Link direct device
File
J\
register
R, ZR
Bit
*2
K4M16)
Ex.
JP.SWRITE Jn (S1) (S2)
GP.SWRITE Un (S1) (S2)
Available devices
Intelligent function
module device
U\G
Word
).
H
(D1)
or
(D2) (D3)
" "
(D1)
*3*4
(D1)
or (D2) (D3)
" "
(D1)
*3*4
Constant
Index register
Zn
K, H





Others
$