Mitsubishi Electric QJ71GF11-T2 User Manual page 212

4.
Select the station to be diagnosed from "Select Station" or "Network Status".
• ,
• A disconnected station that has performed data link is indicated with the
A disconnected station that has been set in the network configuration settings but has not yet performed
data link is displayed on the right end of the area.
However, even if a disconnected station had performed data link, it is displayed on the right end of the
area in the following cases.
• A station that was reconnected to a network after cable disconnection/insertion or power-off and power-on of
• A disconnected station with the station icon deleted in the network map by clicking the
• is displayed on the icon of a cable where a communication error occurs. To check the details of the
communication error, click the neighboring stations of
• is displayed if loopback is performed due to error such as cable disconnection. (When the master/
local module with a serial number (first five digits) of "17052" or later is the master station)
• is displayed if the network is configured in ring topology although the loopback function is disabled.
Take a corrective action according to
• is displayed if the network is configured in star topology although the loopback function is enabled.
Take a corrective action according to
• is displayed if the network is incorrectly configured in ring topology. Take a corrective action
according to
210
, or is displayed on the module icon of the station where an error occurs.
the system and remains disconnected
Page 213, Section 9.2 (2)
.
Page 213, Section 9.2 (2)
.
Page 213, Section 9.2 (2)
.
.
Disconnected station
icon in the network map.
button