3.
Open the network configuration setting window and set parameters as follows.
Project window
4.
Open the refresh parameter window and set parameters as follows.
Project window
5.
Write the parameters to the CPU module on the master station. Then reset the CPU module or turn
off and on the power.
[Online]
[Write to PLC]
In this setting example, default settings are used for the parameters other than those described. For the parameter setting,
refer to the following.
(
Page 81, CHAPTER 7)
[Parameter]
[Network Parameter]
button
[Parameter]
[Network Parameter]
button
RESET
or Power OFF
CHAPTER 11 PROGRAMMING
[Ethernet/CC IE/MELSECNET]
[Ethernet/CC IE/MELSECNET]
ON
11
403