Network Operation Settings - Mitsubishi Electric QJ71GF11-T2 User Manual

7.4

Network Operation Settings

Set operating status of a network if a data link error occurs or the CPU module is set to STOP.
In addition, the IP address of a master/local module is set to communicate data with Ethernet devices over CC-Link IE
Field Network.
1.
Set network setting parameters. (
2.
Open the setting window.
Project window
3.
Set parameters in the window.
Item
Parameter Name Enter the name of network operation setting parameters if desired.
Select whether to hold or clear data input from the slave station where
Data Link Faulty Station
Setting
a data link error has occurred. (
Select whether to hold or clear cyclic data output when the CPU
Output Setting During
module mounted with the master/local module is set to STOP.
CPU STOP
(
[Parameter]
button
Description
Page 140, Section 8.1.7)
Page 142, Section 8.1.8)
Page 84, Section 7.2)
[Network Parameter] [Ethernet/CC IE/MELSECNET]
Up to 8 characters
• Turn OFF or 0 Clear Input Data (RX/
• Hold Input Data
(Default: Turn OFF or 0 Clear Input
Data (RX/RY))
• Hold
• Clear (ALL OFF)
(Default: Hold)
CHAPTER 7 PARAMETER SETTING
Setting range
RY)
101
7