Setting Data - Mitsubishi Electric QJ71GF11-T2 User Manual

(1) Setting data

Setting data
Jn
Un
(S1)
(S2)
(D1)
(D2)
248
Description
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station
Access
Start I/O number of the master/local module of the own station
(00 to FE : Upper two digits of the I/O number expressed in
H
three digits)
Start device of the own station where control data is stored
( Page 249, Section 10.4 (1) (a))
Start device of the target station where data to be read is stored
( Page 251, Section 10.4 (1) (b))
Start device of the own station where read data is stored
A continuous area for the read data length is required
( Page 251, Section 10.4 (1) (c))
The device of the own station that turns on for one scan upon
completion of the instruction.
If the instruction fails, (D2)+1 also turns on.
Set by Data type
16-bit binary
User
Device name
System
Bit