Mitsubishi Electric QJ71GF11-T2 User Manual page 287

Device Item
Channels used by
(S1)+2
own station
Target station's
(S1)+3
channel
Target station's
(S1)+4
network No.
Target station
(S1)+5
number

(S1)+6
Setting data
Specify the channels to be used by the own station.
( Page 241, Section 10.2.2 (1))
Specify the channel of the target station where data is stored.
Specify the network No. of the target station.
1 to 239: Network No.
254: Specify this when 254 is set for Jn.
Specify the target station number.
(1) Station number specification
Master station: 125 (7D )
H
Master operating station: 126 (7E
supporting the submaster function (
8))
Local station, intelligent device station, submaster station: 1 to
120
When 125 (7D ) is set, the module always accesses the master
H
station (station number 0). When 126 (7E
submaster function is used, the module accesses the station
operating as a master operating station.
To increase the reliability of data, it is recommended to execute
the instruction with the execution type in (S1)+0 set to "1: With
arrival confirmation".
(2) Group specification (The target station is on a network other
than CC-Link IE Field Network.)
81 to A0 : All stations in Group No.1 to No.32
H H
(It can be set when the execution type set for (S1)+0 is "0:
Without arrival confirmation".)
Group No.1: 81
Group No.2: 82
Group No.32: A0
(3) All stations specification
FF : All stations on the target station's network No. (excluding
H
the own station)
(It can be set when the execution type set for (S1)+0 is "0:
Without arrival confirmation".)
When using the group specification or all stations specification
• The group specification cannot be used for CC-Link IE Field
Network stations.
• Writing of the data cannot be confirmed on the target station. For
whether data was written normally, check the device of the write
target station.
• Data cannot be written to the station with the station number
already in use or the station with no station number setting. Correct
the error then execute the instruction.
Unused
CHAPTER 10 DEDICATED INSTRUCTIONS
) (only for modules
H
Page 546, Appendix
) is set and the
H
H
H
H
Setting range Set by
1 and 2 User
1 to 8 (channel
range available for User
target station)
1 to 239
User
254
125 (7D )
H
126 (7E )
H
1 to 120 User
81 to A0
H H
FF
H
0 User
285
10