Configuring Rip On The Switch Using The Cli; Modifying Rip Interfaces; Modifying Rip Interfaces Using The Web Agent; Rip Interfaces Dialog Box - Avaya Cajun P550R User Manual

Configuring RIP
on the Switch
Using the CLI

Modifying RIP Interfaces

Modifying RIP
Interfaces Using
the Web Agent
Cajun P550/P880/P882 Switch User Guide
Configuring the Routing Information Protocol (RIP)
To configure the RIP globally on your switch using the CLI, enter the
following command in Configure mode:
cajun (configure)# router rip
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
You can modify RIP interfaces from either the web agent or the CLI.
To modify RIP interfaces using the CLI from the web agent:
1. Select Interfaces from the Routing > IP > RIP group on the
Web Agent window. The RIP Interfaces dialog box opens
(Figure 10-2).
*Note: Due to its length, the RIP interface dialog box is
divided into two parts in Figure 10-2.
Figure 10-2. RIP Interfaces Dialog Box
10-3