Reset Rip Statistics; Rip - HP FlexNetwork 3600 v2 Series Command Reference Manual

reset rip statistics

Syntax
reset rip process-id statistics
View
User view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use reset rip statistics to clear the statistics of the specified RIP process. This command can clear
the statistics of debugging.
Examples
# Clear statistics in RIP process 100.
<Sysname> reset rip 100 statistics

rip

Syntax
rip [ process-id ] [ vpn-instance vpn-instance-name ]
undo rip [ process-id ] [ vpn-instance vpn-instance-name ]
View
System view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535. The default is 1.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN. vpn-instance-name is a
case-sensitive string of 1 to 31 characters. If no VPN is specified, the RIP process will run under the
public network.
Description
Use rip to create a RIP process and enter RIP view.
Use undo rip to disable a RIP process.
By default, no RIP process runs.
You must create a VPN instance before you apply a RIP process to it. For related configuration, see
the ip vpn-instance command in the MCE Command Reference.
You must enable the RIP process before configuring the global parameters. This limitation is not for
configuration of interface parameters.
The configured interface parameters become invalid after you disable the RIP process.
46