Apply Ip-Precedence - HP FlexNetwork 3600 v2 Series Command Reference Manual

View
PBR policy node view
Default level
2: System level
Parameters
ip-address: IP address of the next hop.
direct: Specifies the current next hop as valid when it is a directly connected next hop.
track track-entry-number: Specifies a track entry. The track-entry-number argument is in the range
of 1 to 1024.
Description
Use apply ip-address next-hop to set the next hop(s) for packets.
Use undo apply ip-address next-hop to remove the configuration.
You can specify up to two next hops in one command line.
Using the undo apply ip-address next-hop command with a next hop specified removes the next
hop. Using this command without any next hop specified removes all next hops.
The next hop must belong to the public network instead of a VPN.
Examples
# Set the directly connected next hop to 1.1.1.1.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-pbr-aa-11] apply ip-address next-hop 1.1.1.1 direct

apply ip-precedence

Syntax
apply ip-precedence value
undo apply ip-precedence
View
PBR policy node view
Default level
2: System level
Parameters
value: Sets the precedence for IP packets. Eight precedence values (0 to 7) are available. Each
precedence value corresponds to a precedence type, as shown in
precedence value or a precedence type for IP packets.
Table 97 IP precedences and the corresponding types
Precedence value
0
1
2
3
Precedence type
routine
priority
immediate
flash
439
Table 97. You can set either a