Peer Capability-Advertise Route-Refresh - HP FlexNetwork 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
Parameters
Use peer capability-advertise orf non-standard to enable the non-standard ORF capability (the
early implementation of ORF is different from that defined in RFC) for a BGP peer or peer group.
Use undo peer capability-advertise orf non-standard to disable the non-standard ORF capability
for the BGP peer or peer group.
By default, the non-standard ORF capability is not enabled for a BGP peer or peer group.
This command needs to be configured when the peer supports only non-standard ORF.
Related commands: peer capability-advertise orf.
Examples
# Enable the non-standard ORF capability for the BGP peer 1:2::3:4 (suppose the BGP peer 1:2::3:4
can only send non-standard ORF packets).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] peer 1:2::3:4 capability-advertise orf non-standard
[Sysname-bgp-af-ipv6] peer 1:2::3:4 capability-advertise orf ip-prefix both

peer capability-advertise route-refresh

Syntax
peer { ipv6-group-name | ipv6-address } capability-advertise route-refresh
undo peer { ipv6-group-name | ipv6-address } capability-advertise route-refresh
View
IPv6 address family view
Default level
2: System level
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
Description
Use peer capability-advertise route-refresh to enable IPv6 BGP route-refresh.
Use undo peer capability-advertise route-refresh to disable the function.
By default, route-refresh is enabled.
Examples
# Disable route-refresh of peer 1:2::3:4.
<Sysname> system-view
381