HP FlexNetwork 3600 v2 Series Command Reference Manual page 93

Field
Router ID
Address
GR State
State
Mode
Priority
DR
BDR
MTU
Dead timer due in 33 sec
Neighbor is up for 02:03:35
Authentication Sequence
Neighbor state change count
# Display brief OSPF neighbor information.
<Sysname> display ospf peer
Area: 0.0.0.0
Router ID Address
1.1.1.2 1.1.1.2
Description
Neighbor router ID.
Neighbor router address.
GR state.
Neighbor state:
•
•
•
•
•
•
•
•
Neighbor mode for LSDB synchronization.
Neighboring router priority.
The DR on the interface's network segment.
The BDR on the interface's network segment.
Interface MTU.
Dead timer times out in 33 seconds.
The neighbor has been up for 02:03:35.
Authentication sequence number.
Count of neighbor state changes.
OSPF Process 1 with Router ID 1.1.1.1
Neighbor Brief Information
Pri Dead-Time Interface
1 40
Down—This is the initial state of a neighbor conversation.
Init—In this state, the router has seen a Hello packet from
the neighbor. However, the router has not established
bidirectional communication with the neighbor (the router
itself did not appear in the neighbor's hello packet).
Attempt—Available only in an NBMA network, Under this
state, the OSPF router has not received any information
from a neighbor for a period but can send Hello packets at
a longer interval to keep neighbor relationship.
2-Way—In this state, communication between the two
routers is bidirectional. The router itself appears in the
neighbor's Hello packet.
Exstart—The goal of this state is to decide which router is
the master, and to decide upon the initial Database
Description (DD) sequence number.
Exchange—In this state, the router is sending DD
packets to the neighbor, describing its entire link-state
database.
Loading—In this state, the router sends Link State
Request packets to the neighbor, requesting more recent
LSAs.
Full—In this state, the neighboring routers are fully
adjacent.
Vlan11
81
State
Full/DR