Rip Bfd Enable; Rip Default-Route - HP FlexNetwork 3600 v2 Series Command Reference Manual

[Sysname-Vlan-interface10] rip version 2
[Sysname-Vlan-interface10] rip authentication-mode md5 rfc2453 rose

rip bfd enable

Syntax
rip bfd enable
undo rip bfd enable
View
Interface view
Default level
2: System level
Parameters
None
Description
Use rip bfd enable to enable BFD on the RIP interface.
Use undo rip bfd enable to restore the default and delete the relevant BFD session.
By default, a RIP interface is not enabled with BFD.
BFD echo-mode detection only works for a RIP neighbor one hop away.
Using the undo peer command does not delete the neighbor relationship at once and cannot bring
down the BFD session at once.
Examples
# Enable BFD on RIP interface VLAN-interface 11.
<Sysname> system-view
[Sysname] interface vlan-interface 11
[Sysname-Vlan-interface11] rip bfd enable

rip default-route

Syntax
rip default-route { { only | originate } [ cost cost ] | no-originate }
undo rip default-route
View
Interface view
Default level
2: System level
Parameters
only: Advertises only a default route.
originate: Advertises a default route and other routes.
cost: Cost of the default route, in the range of 1 to 15. The default is 1.
no-originate: Advertises routes other than a default route.
48