Silent-Interface(Ospfv3 View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

Parameters
router-id: 32-bit router ID, in IPv4 address format.
Description
Use router-id to configure the OSPFv3 router ID.
Use undo router-id to remove a configured router ID.
Router ID is the unique identifier of a device running an OSPFv3 process in the AS. The OSPFv3
process cannot run without a Router ID.
Make sure that different processes have different Router IDs.
By configuring different router IDs for different processes, you can run multiple OSPFv3 processes
on a router.
Related commands: ospfv3.
Examples
# Configure the Router ID as 10.1.1.3 for OSPFv3 process 1.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] router-id 10.1.1.3

silent-interface(OSPFv3 view)

Syntax
silent-interface { interface-type interface-number | all }
undo silent-interface { interface-type interface-number | all }
View
OSPFv3 view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
all: Specifies all interfaces.
Description
Use silent-interface to disable the specified interface from receiving and sending OSPFv3 packets.
Use undo silent-interface to restore the default.
An interface is able to receive and send OSPFv3 packets by default.
Multiple processes can disable the same interface from receiving and sending OSPFv3 packets, but
use of the silent-interface command takes effect only on interfaces enabled with the current
process.
Examples
# Disable an interface from receiving and sending OSPFv3 packets in OSPFv3 processes 100 and
200.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] router-id 10.110.1.9
[Sysname-ospfv3-100] silent-interface vlan-interface 10
326