Default Local-Preference (Bgp/Bgp-Vpn Instance View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

Use undo default ipv4-unicast to disable the default use of IPv4 unicast address family for the
peers that are established using the peer as-number command.
The use of IPv4 unicast address family is enabled by default.
The default ipv4-unicast or undo default ipv4-unicast command applies to only BGP peers that
are established after it is executed.
The default ipv4-unicast or undo default ipv4-unicast command applies to only BGP peers that
are established using the peer as-number command.
After executing the undo default ipv4-unicast command, you can use the peer enable command
to enable the use of IPv4 address family for a peer.
Examples
# Enable the default use of IPv4 unicast address family for the peers that are established using the
peer as-number command.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default ipv4-unicast

default local-preference (BGP/BGP-VPN instance view)

Syntax
default local-preference value
undo default local-preference
View
BGP view, BGP-VPN instance view
Default level
2: System level
Parameters
value: Default local preference, in the range of 0 to 4294967295. The larger the value is, the higher
the preference is.
Description
Use default local-preference to configure the default local preference.
Use undo default local-preference to restore the default value.
By default, the default local preference is 100.
Using this command can affect BGP route selection.
Examples
# In BGP view, set the default local preference to 180.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default local-preference 180
# In BGP-VPN instance view, set the default local preference to 180. (The VPN has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] default local-preference 180
196