HP FlexNetwork 3600 v2 Series Command Reference Manual page 304

Transmit Delay is 1 sec, State Point-To-Point, Priority 1
No designated router on this link
No backup designated router on this link
Timer interval configured, Hello: 10, Dead: 40, Wait: 40, Retransmit: 5
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
IPsec policy name: policy001, SPI: 300
BFD: Enabled
Table 59 Command output
Field
Interface ID
IPv6 Prefixes
OSPFv3 Process
Area
Instance ID
Router ID
Network Type
Cost
Transmit Delay
State
Priority
No designated router on this link
No backup designated router on this link
Timer interval configured
Hello due in 00:00:02
Neighbor Count
Adjacent neighbor count
IPsec policy name
SPI
BFD
Description
Interface ID.
IPv6 Prefix.
OSPFv3 Process.
Area ID.
Instance ID.
Router ID.
Network type of the interface.
Cost value of the interface.
Transmission delay of the interface.
Interface state.
DR priority of the interface.
No designated router on this link.
No backup designated router on this link.
Time intervals in seconds configured on the
interface:
•
Hello—Hello interval.
•
Dead—Dead interval.
•
Wait—After this timer expires, the interface
quits from the waiting state.
•
Retransmit—LSA retransmission interval.
Hello packet will be sent in 2 seconds.
Number of Neighbors on the interface
Number of Adjacencies on the interface
IPsec policy used on the interface
SPI defined in the IPsec policy
BFD status on the interface (enabled or disabled).
292