Stub-Router - HP FlexNetwork 3600 v2 Series Command Reference Manual

View
OSPF area view
Default level
2: System level
Parameters
default-route-advertise-always: Usable only on a stub ABR. With this keyword configured, the
ABR advertises a default route in a Type-3 LSA into the stub area regardless of whether FULL-state
neighbors exist in the backbone area. Without this keyword, the ABR advertises a default route in a
Type-3 LSA into the stub area only when at least one FULL-state neighbor exists in the backbone
area.
no-summary: Usable only on a stub ABR. With this keyword configured, the ABR advertises only a
default route in a Summary LSA into the stub area (such a stub area is a totally stub area).
Description
Use stub to configure an area as a stub area.
Use undo stub to remove the configuration.
No area is stub area by default.
To cancel the default-route-advertise-always or the no-summary configuration on the ABR,
execute the stub command again to overwrite it.
To configure an area as a stub area, all routers attached to it must be configured with this command.
Related commands: default-cost.
Examples
# Configure Area 1 as a stub area.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] stub

stub-router

Syntax
stub-router
undo stub-router
View
OSPF view
Default level
2: System level
Parameters
None
Description
Use stub-router to configure the router as a stub router.
Use undo stub-router to restore the default.
By default, no router is configured as a stub router.
122