Apply Isis - HP FlexNetwork 3600 v2 Series Command Reference Manual

Parameters
rt route-target: Sets the route target (RT) extended community attribute, a string of 3 to 21
characters.
A route-target has one of the following forms:
•
16-bit AS number—32-bit self-defined number, for example, 101:3
•
32-bit IP address—16-bit self-defined number, for example, 192.168.122.15:1
•
32-bit AS number—16-bit self-defined number, for example, 70000:3. The AS number should
be no less than 65536.
&<1-16>: Indicates the argument before it can be entered up to 16 times.
additive: Adds the specified attribute to the original RT community attribute.
Description
Use apply extcommunity to apply the specified RT extended community attribute to BGP routes.
Use undo apply extcommunity to remove the clause configuration.
No RT extended community attribute is set for BGP routing information by default.
Examples
# Configure node 10 in permit mode of routing policy policy1: If a BGP route matches AS path list 1,
add the RT extended community attribute 100:2 to the route.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply extcommunity rt 100:2 additive

apply isis

Syntax
apply isis { level-1 | level-1-2 | level-2 }
undo apply isis
View
Routing policy view
Default level
2: System level
Parameters
level-1: Redistributes routes into IS-IS level-1.
level-1-2: Redistributes routes into both IS-IS level-1 and level-2.
level-2: Redistributes routes into IS-IS level-2.
Description
Use apply isis to redistribute routes into a specified ISIS level.
Use undo apply isis to remove the clause configuration.
No IS-IS level is set by default.
Examples
# Configure node 10 in permit mode of routing policy policy1: If a route has a tag of 8, redistribute
the route to IS-IS level-2.
413