Ripng Configuration Commands; Checkzero; Default Cost (Ripng View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

RIPng configuration commands

The term "router" in this chapter refers to both routers and Layer 3 switches.

checkzero

Syntax
checkzero
undo checkzero
View
RIPng view
Default level
2: System level
Parameters
None
Description
Use checkzero to enable the zero field check on RIPng packets.
Use undo checkzero to disable the zero field check.
The zero field check is enabled by default.
Some fields in RIPng packet headers must be zero. These fields are called "zero fields". You can
enable the zero field check on RIPng packet headers. If any such field contains a non-zero value, the
RIPng packet will be discarded.
Examples
# Disable the zero field check on RIPng packet headers of RIPng 100.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] undo checkzero

default cost (RIPng view)

Syntax
default cost cost
undo default cost
View
RIPng view
Default level
2: System level
Parameters
cost: Default metric of redistributed routes, in the range of 0 to 16.
Description
Use default cost to specify the default metric of redistributed routes.
265