Enable Ipsec-Policy (Ospfv3 Area View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Vlan-interface20, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Retransmit: 5
Hello due in 00:00:02
Adjacency state :Full
IPsec policy name: policy001, SPI: 300
Table 77 Command output
Field
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area 0.0.0.1 via interface Vlan-interface20
instance ID
Local address
Remote address
Transmit Delay
State
Timer intervals configured, Hello: 10, Dead: 40, Wait:
40, Retransmit: 5
Hello due in 00:00:02
Adjacency state
IPsec policy name
SPI

enable ipsec-policy (OSPFv3 area view)

Syntax
enable ipsec-policy policy-name
undo enable ipsec-policy
View
OSPFv3 area view
Default level
2: System level
Parameters
policy-name: IPsec policy name, a string of 1 to 15 characters.
Description
Use enable ipsec-policy to apply an IPsec policy in the OSPFv3 area.
Description
The virtual link VLINK1 to router 1.1.1.1 is up.
Interface Vlan-interface20 in transit area 0.0.0.1.
Instance ID.
Local IPv6 address.
Remote IPv6 address.
Transmit delay of sending LSAs.
Interface state.
Timer intervals in seconds:
•
Hello—10
•
Dead—40
•
Wait—40
•
Retransmit—5
Send hello packets in 2 seconds.
Adjacency state.
IPsec policy used on the virtual link.
SPI defined in the IPsec policy.
309