Ospf Authentication-Mode - HP FlexNetwork 3600 v2 Series Command Reference Manual

ospf authentication-mode

Syntax
For MD5/HMAC-MD5 authentication:
ospf authentication-mode { hmac-md5 | md5 } key-id [ cipher | plain ] password
undo ospf authentication-mode { hmac-md5 | md5 } key-id
For simple authentication:
ospf authentication-mode simple [ cipher | plain ] password
undo ospf authentication-mode simple
View
Interface view
Default level
2: System level
Parameters
hmac-md5: HMAC-MD5 authentication.
md5: MD5 authentication.
simple: Simple authentication.
key-id: Authentication key ID, in the range of 1 to 255.
cipher: Sets a ciphertext password.
plain: Sets a plaintext password.
password: Sets the authentication password. This argument is case sensitive. For simple
authentication mode, it is plaintext string of 1 to 8 characters, or a ciphertext string of 1 to 41
characters. For MD5/HMAC-MD5 authentication mode, it is a plaintext string of 1 to 16 characters, or
a ciphertext string of 1 to 53 characters.
Description
Use ospf authentication-mode to set the authentication mode and authentication parameters on
an interface.
Use undo ospf authentication-mode to remove specified configuration.
By default, no authentication is available on an interface.
Interfaces attached to the same network segment must have the same authentication password and
mode.
The authentication password, set in either plain text or cipher text, is saved to the configuration file in
cipher text.
If neither cipher nor plain is specified, cipher applies to the MD5/HMAC-MD5 authentication mode
and plain applies to the simple authentication mode, by default.
Related commands: authentication-mode.
Examples
# Configure the network 131.119.0.0/16 in Area 1 to support MD5 authentication, and set the
interface key ID to 15 and plaintext authentication password to abc.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
106