Isis Circuit-Type P2P; Isis Cost - HP FlexNetwork 3600 v2 Series Command Reference Manual

[Sysname-Vlan-interface10] isis circuit-level level-1

isis circuit-type p2p

Syntax
isis circuit-type p2p
undo isis circuit-type
View
Interface view
Default level
2: System level
Parameters
None
Description
Use isis circuit-type p2p to configure the network type for an interface as P2P.
Use undo isis circuit-type to cancel the configuration.
By default, the network type of an interface depends on the physical media. (The network type of a
VLAN interface is broadcast.)
Interfaces with different network types operate differently. For example, broadcast interfaces on a
network need to elect a DIS and flood CSNP packets to synchronize the LSDBs, and P2P interfaces
on a network need not elect a DIS and have a different LSDB synchronization mechanism.
If only two routers exist on a broadcast network, configure the network type of attached interfaces as
P2P to avoid DIS election and CSNP flooding, saving network bandwidth and speeding up network
convergence.
You can perform this configuration only for a broadcast network with only two attached routers.
NOTE:
This command is not supported in loopback interface view.
Examples
# Configure the network type of VLAN-interface 10 as P2P.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis enable
[Sysname-Vlan-interface10] isis circuit-type p2p

isis cost

Syntax
isis cost value [ level-1 | level-2 ]
undo isis cost [ value ] [ level-1 | level-2 ]
View
Interface view
162