Default Ipv4-Unicast; Default Local-Preference (Bgp/Bgp-Vpn Instance View) - HP 6125G Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for 6125G:
- Command reference manual (426 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
default ipv4-unicast
Syntax
default ipv4-unicast
undo default ipv4-unicast
View
BGP view
Default level
2: System level
Parameters
None
Description
Use default ipv4-unicast to enable the default use of IPv4 unicast address family for the peers that are
established using the peer as-number command.
Use undo default ipv4-unicast to disable the default use of IPv4 unicast address family for the peers that
are established using the peer as-number command.
The use of IPv4 unicast address family is enabled by default.
The default ipv4-unicast or undo default ipv4-unicast command applies to only BGP peers that are
established after it is executed.
The default ipv4-unicast or undo default ipv4-unicast command applies to only BGP peers that are
established using the peer as-number command.
After executing the undo default ipv4-unicast command, you can use the peer enable command to
enable the use of IPv4 address family for a peer.
Examples
# Enable the default use of IPv4 unicast address family for the peers that are established using the peer
as-number command.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default ipv4-unicast
default local-preference (BGP/BGP-VPN instance view)
Syntax
default local-preference value
undo default local-preference
View
BGP view, BGP-VPN instance view
Default level
2: System level
135
Advertisement
Table of Contents
