Vpn-Instance-Capability Simple; Vpn-Target (Vpn Instance View/Ipv4 Vpn View/Ipv6 Vpn View) - HP FlexFabric 12500 Command Reference Manual

Examples
# Configure VPN ID 20:1 for the VPN instance vpn1.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] vpn-id 20:1
Related commands
display ip vpn-instance

vpn-instance-capability simple

Use vpn-instance-capability simple to disable OSPF routing loop detection for a VPN instance.
Use undo vpn-instance-capability to restore the default.
Syntax
vpn-instance-capability simple
undo vpn-instance-capability
Default
OSPF routing loop detection is enabled for a VPN instance.
Views
OSPF view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
In an MCE network, you must disable OSPF routing loop detection for a VPN instance on the MCE.
Otherwise, the MCE does not receive OSPF routes from the PE.
This command is applicable only to OSPF view for a VPN instance.
Examples
# Disable OSPF routing loop detection for VPN instance vpna.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpna
[Sysname-ospf-100] vpn-instance-capability simple

vpn-target (VPN instance view/IPv4 VPN view/IPv6 VPN view)

Use vpn-target to configure route targets for a VPN instance.
Use undo vpn-target to remove the specified or all route targets of a VPN instance.
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
99