Ensure that you have an appropriate cable available. See
Connections for an ACX5000 Router" on page
To connect a ACX5000 router to a network for out-of-band management (see
1. Connect one end of the cable to one of the management ports (labeled C0 and
C1) on the ACX5000 router.
2. Connect the other end of the cable to the management router (see
Figure 43: Connecting a ACX5000 Router to a Network for Out-of-Band Management
To Management Port
(on Device)
SEE ALSO
Management Panel of an ACX5000 Router | 47
Management Port Connector Pinouts for an ACX5000 Router | 96
Initially Configuring the ACX5000 Router
You must perform the initial configuration of the ACX5000 router through the console port using the
command-line interface (CLI).
Before you begin connecting and configuring an ACX5000 router, set the following parameter values on
the console server or PC:
Baud Rate—9600
Flow Control—None
"Cable Specifications for Console and Management
95.
Management
Network
Figure 43 on page
Figure 43 on page
122).
Management PC
Management PC
Management PC
122
122):