Inspection On Ignition Coil; Ignition Coil Replacement; Inspection Of Pulse Generator - TGB BLADE 600 Service Manual

Inspection on Ignition Coil

Disengage the connector of the ignition coil
and the spark plug cap.
Measure the resistance between the terminals of
the primary winding.
Standard resistance: 2.9
Remove the cap from the spark plug and
measure the resistance between the spark plug
and the primary winding.
Standard resistance:
With no cap: 15.0
With cap:

Ignition Coil Replacement

Loosen the lock bolt and replace the ignition coil
if necessary.

Inspection of Pulse Generator

Disconnect the coupler of the pulse generator
and measure the resistance between the
terminals of green/white and blue/yellow.
Standard resistance: 50~170Ω
Ω
± 10%
Ω
± 10%
Ω
20.0±10%K
16. ELECTRICAL SYSTEM
16-9