How To View Eps Mode Selection; How To Change Eps Mode - TGB BLADE 600 Service Manual

15-2. ELECTRIC POWER STEERING

How to View EPS Mode Selection

1. To view the active EPS assist mode, press
MODE button from the dashboard and move
to EPS select page, the EPS page will
blinking then press the RESET button to
engage the EPS assist.
2. The active EPS mode will display in the
middle right portion of speedometer.

How to Change EPS Mode

To change EPS mode, press the RESET button
on the EPS function page, The EPS system will
engage or disengage and display "MIN",
"MAX" and blank (OFF).
When EPS system is malfunction, the function
block will displayed "FAIL". And the bottom of
dashboard will show DTC code with "Cxxxx".
Code Problem Caused
C1511 Torque sensor connector poor contact
C1512
C1513
Torque sensor abnormal
C1514
C1515
C1521 Motor connector poor contact
C1522
C1523
C1524 Motor abnormal
C1525
C1526
C1532 Controller current sensor abnormal
C1531
Controller abnormal
C1533
C1536 Controller voltage too high
C1538 Controller overheat
15-2-4