Radiator Disassembly, Assembly And Installation - TGB BLADE 600 Service Manual

12. COOLING SYSTEM
Loosen the radiator 4 bolts. Remove coolant
upper side pipes.
Remove coolant outlet pipe.
Disconnect the couplers for the cooling fan
switch and fan motor, and then remove radiator
and cooling fan.
Disassembly
Loosen the 4 bolts from the fan duct, and
then remove the fan duct.
Loosen 4 screws from the fan motor, and take
off the fan motor.
Remove nut to remove the fan from fan motor.
Assembly
Install fan motor onto fan duct and insert the
fan into the motor shaft.
Apply a coat of the adhesive to the shaft thread
of the motor, and then install the washer and the
lock nut.
Tighten the fan duct onto the radiator with 4 bolts.
Please refer to chapter 17 for the inspection of
the cooling fan switch.
Caution
Liquid packing must be applied to the cooling
fan switch before installing to avoid
damaging the radiator.
Installation
Install the removed parts in the reverse order of
removal.
Install radiator in the reverse order of removal.
Upon completion, check for any leakage.
12-6