PIVOT GEAR DISASSEMBLE
▪ Remove four bolts and lightly knock out the
housing.
▪ Check the oil seal and O ring, replace if
necessary.
▪ Using special tool #560010 to remove the ring
snap.
▪ Apply rubber hammer from the inside of case
lightly knock out the gear to remove the shaft
from the case.
NOTE: Beware the knocking might damage the
bearing.
▪ Check the bearing, replace if necessary.
▪ Before install new bearing, apply some
lubricate oil inside the bearing.
9-2.REAR DIFFERENTIAL
9-2-1