Engine Hard To Start Or Can Not Be Started - TGB BLADE 600 Service Manual

A. Engine hard to start or can not be started
Check and adjustment
Loosen carburetor drain bolt to
check if there is gasoline inside
the carburetor
Fuel supplied tom
carburetor sufficient
Remove spark plug, install it into
spark plug cap, and perform a
spark test against engine
ground.
Check if sparks
Perform cylinder compression
pressure test.
Cylinder compression
pressure normal
Re-start by following the
starting procedures
No ignition
Remove the spark plug again
and check it.
Dry spark plug
Remove carburetor after 30
minutes and connect a hose
onto fuel rich circuit. Then blow
the hose with air
Blowing in normal
Fault condition
No fuel is supplied to
carburetor
Weak sparks, no spark
at all
Low compression
pressure or no pressure
There are some signs of
ignition; nut engine can
not be started
Wet spark plug
Blowing clogged
1. GENERAL INFORMATION
Probable causes
● No fuel in fuel tank
● Check if the pipes, fuel tank to carburetor
and intake vacuum, are clogged.
● Float valve clogged
● Lines in fuel tank evaporation
system clogged
● Malfunction of fuel pump
● Loosen or damaged fuel pump
vacuum hose
● Fuel filter clogged
● Malfunction of spark plug
● Spark plug foul
● Malfunction of Ignition Coil set
● Malfunction of AC generator
● Ignition coil is in open or short circuit
● Ignition coil leads open or short circuit
● Malfunction of main switch
● Piston ring seized
● Malfunction of cylinder valves
● Worn cylinder and piston ring
● Cylinder gasket leak
● Sand hole in compression parts
● Malfunction of throttle valve operation
● Air sucked into intake manifold
● Incorrect ignition timing
● Fuel level in carburetor too high
● Malfunction of throttle valve operation
● Throttle valve opening too wide
● Malfunction of automatic by- starter
1-15