TGB BLADE 600 Service Manual page 93

NOTE:
Injector voltage can be detected only 3
seconds after ignition switch is turned ON.
Is the voltage OK?
• L/G wire open or shorted to ground,
or poor 47 connection (cylinder
side)
• If wire and connection are OK,
intermittent trouble or faulty ECU.
YES
• Recheck each terminal and wire
harness for open circuit and poor
connection.
• Replace the ECU with a known
good one, and inspect it again.
NO Open circuit in the R wire
3) After repairing the trouble, clear the DTC
using Diagnosis tool.
4-1. FUEL INJECTION SYSTEM
47
4-1-45