Drive System; Front Drive; Wheel Hub Removal; Wheel Hub Inspection - TGB BLADE 600 Service Manual

9-1. FRONT DIFFERENTIAL

DRIVE SYSTEM

FRONT DRIVE

GENERAL
During assemble/installation, use torque values and service products as in the exploded views.
Clean threads before applying thread locker.
WARNING
Torque wrench tightening specifications must strictly be adhered to.
Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pin, etc.)
must be replaced.
Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory
standards.
WHEEL HUB

Wheel Hub Removal

▪ Lift and support vehicle.
▪ Place the transmission lever on "P".
▪ Remove caliper from knuckle.
▪ Remove the following parts:
- Wheel
- Cotter pin.
- Castellated nut.
- Washer.
▪ Remove wheel hub.

Wheel Hub Inspection

▪ Check wheel hub for cracks or other damages.
▪ Check inner splines for wear or other damages.
▪ If any damage is detected on wheel hub, replace it
with a new one.
Wheel Hub Installation
▪ For installation, reverse the removal procedure.
▪ Install washer with its concave side towards
outward.
TORQUE: 225 Nm.
NOTE: Tighten further castellated nut if required to
align grooves with drive shaft hole.
▪ Install a NEW cotter pin.
9-1-2