Pivot Gear Assemble; Differential Motor Removal And Installation - TGB BLADE 600 Service Manual

9-2. REAR DIFFERENTIAL

PIVOT GEAR ASSEMBLE

▪ Reverse the disassemble procedure install the
shaft and bearing into case.
▪ Apply Loctite #263 on the ring snap, and Apply
special tool #560010 to install.
Torque : 11~12kgf-m
▪ Apply Loctite #263 on the four bolts, and install
the housing and tighten.
Torque : 4.2~4.4kgf-m
DIFFERENTIAL MOTOR
REMOVAL
Disconnected the wiring connector.
Unscrew three differential motor bolts.
INSTALLATION
For installation, reverse the removal procedure.
9-2-2